Solder the end of the wire connected to TP6 to the middle pin of an RCA plug
(ex: The metal on the cartridge socket is grounded.) (Make sure the wire is long enough to exit the case where desired) (Make sure the wire is long enough to exit the case where desired.) Solder a strand of Kynar, or an IDE strand, or similar small-gauge wire to TP6. You may also find it more comfortable to work on TP6 with the LCD panel ribbon cable disconnected (its delicate, so be gentle as you release the ribbon cable) To access TP6, you will need to remove the Didj main-board from the case. On the LeapFrog Pollux Platform, the DAC connection is exposed via Test Pad 6 (TP6) which can be found on the CPU side of the board. The LF1000 Processor contains a current-driven digital-to-analog converter that can drive an external screen via CVBS (composite video). this has been known to work with just the 75 Ohm resistor)
A Didj or Leapster Explorer you are willing to disassemble and solder parts to.This how-to outlines the basic steps to enabling your LeapFrog Pollux Platform device to send a composite video signal to your television.
0 kommentar(er)
